Ask Experts Questions for FREE Help !
Ask
    johnnyb1959c's Avatar
    johnnyb1959c Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 8, 2016, 06:48 PM
    How do I fix the switch on my mixmaster model K?
    I have an old Sunbeam Mixmaster model K from the 1930s. How do I reassemble the switch? Its been awhile since I put a new cord on it and finally got around to attempting to reassemble. Pics would really help. Thanks

Check out some similar questions!

Mixmaster model 10 runs full speed with new cap and resistor [ 0 Answers ]

Bought a model 10 mixmaster worked fine all speeds/suddenly while testing it took off full speed fully bypassing sped control. I have just replaced the power resistor with a part of same value and the same with the cap. Results? Bad Still runs 117volts straight to motor - no speed conrol. I double...

Parts for sunbeam mixmaster 2594 [ 0 Answers ]

I need parts for the inside of the mixmaster, drive gears that turn the beaters

Replace power cord on sunbeam mixmaster 11? [ 0 Answers ]

How do I take apart a Sunbeam Mixmaster, model 11, to replace the power cord? And I would like general disassembly directions for the unit so I can clean out the old, gunky grease and re-lube it.

Will a three-way switch fix this? [ 1 Answers ]

Master Bedroom - I couldn't get my closet single-pole light dimmer switch that I installed to work until I replaced it with a single pole non dimmer. Now it cuts the electricity to half of the room, well at least to the rest of the recessed lights, I didn't check the outlets, too tired. The main...

Disassemble mixmaster [ 2 Answers ]

I have a chrome mixmaster stand mixer, unmarked for model number, voltage or current. It looks very similar to the model 2360, but has an adjustment lever for bowl position. But the big difference from other models I can find pictures of is the beater release eject mechanism. The top handle...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.