Ask Experts Questions for FREE Help !
Ask
    sparky65's Avatar
    sparky65 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 2, 2016, 04:42 PM
    Keeprite mid-efficiency furnace problem
    I have a Keeprite mid-efficiency furnace that's just over 11 years old. I just had my central air conditioner replaced with a Keeprite (seer 13) air conditioner. The furnace runs fine during the winter but when I went to turn on the a.c. the furnace blower motor works but the a.c. unit doesn't turn on. I switched the fan control to "auto" and the temperature switch to "cool" and I varied the temperature on the thermostat but the a.c. still doesn't come on. Any suggestions?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Aug 2, 2016, 06:34 PM
    Disconnect not turned to ON, Contactor, wire to contactor, bad start capacitor, thermostat, start with those items. Will require a basic understanding of how things work and also how to test.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier Weathermaker 8000 mid-efficiency 58WAV upflow loss of flame [ 0 Answers ]

Carrier Weathermaker 8000 mid-efficiency 58WAV upflow series 100 Problem: flame cut-out in a continuing cycle, with duration of burner on time decreasing with each successive loss of flame : no lock-out, cycle continuous : code 31 after...

Noise problem with new Carrier high efficiency furnace [ 0 Answers ]

Had a new furnace installed in my crawl space underneath bedroom - now noise when the blower runs wakes us up. Looking for solutions, Have carpet in bedroom, insulation in crawl space.

Hiel DC90 ultra efficiency furnace burner problem [ 1 Answers ]

I have a Hiel DC90 ultra efficiency furnace. It has been sitting all summer, and I tried starting it up today. So I turned the thermostat on raised the temperature, the furnace starts up I hear the first click, then I hear the second click, then the pilot ignite's, the inside of the burner box...

Keeprite 9MPT high efficiency furnace turns on when heat is not called for? [ 0 Answers ]

I have a 2-3 yearold keeprite that starts up for a few seconds then shuts down. This is when heat is not called for. If I turn up the thermostate to a higher temature so heat is called for it starts up and heats till proper temp is reached and shuts down as requested. Now assuming the...

Keeprite furnace [ 1 Answers ]

Between heating cycles the exaust fan comes on,the pilot glows,there is a little green light that flashes on ,off ,in the following sequences , o__000000__0__000000 , this lasts for about 2 to 3 minutes. Then the exhaust fan and pilot go off. No burner ignition occurs during this. This sometimes...

View more questions Search