Ask Experts Questions for FREE Help !
Ask
    Allevundroz's Avatar
    Allevundroz Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 26, 2016, 07:52 PM
    motor size for pump 125x80x400
    we are requested to install a motor to drive a Hydro Titan brand pump with a size of 125x80x400 on its nameplate.however there are some issues regarding a 15kw motor previously installed and eventually getting burnt. We are trying to verify the correct motor size to drive the pump given it suction diameter being 125mm and discharge diameter being 80mm with an effective head of 25m.
    talaniman's Avatar
    talaniman Posts: 54,325, Reputation: 10855
    Expert
     
    #2

    Jul 26, 2016, 08:36 PM
    Verification of recommended motor size for pumps is done through the pump manufacturer.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What size of Motor Protection breaker for a motor [ 1 Answers ]

What size of breaker for the different size motors... where can I find? What size breaker to use for the different size motors

We have lost water to our hose, in the pump house the submersible pump motor trips [ 3 Answers ]

We lost water, so we went to the pump house the submersible pump motor tripped, we clicked the reset button and it builds pressure to about 38 PSI then trips again, so we replaced the motor, no change does same problem, so we replaced the 30/50 pressure switch, same problem exists.

WELL PUMP: Changed pump pipe size from 1/2" to 3/4" on a well pump [ 2 Answers ]

I changed pump pipe size from 1/2" to 3/4" on a well pump. Now the system will not stop running. The piping was put back just like it was, except for the different size. No additional valves or anything different.

My janitrol pump motor tries to start but just cut on & off without the motor going [ 0 Answers ]

In the air condition mode the heat pump tries to start up but turns on & off like flicking a light switch. A air conditioning service co. replaced a relay and it worked when he was here but on our first try with it after he left exactly the same Problem returned. The same tech. came back &...

Pump lost prime and overheated motor runs but does not pump is the pump fried [ 4 Answers ]

Over night the pump lost primed and melted the sched. 40 fittings I replaced all the fittings and cannot get pump to prime the motor runs is it possible that the propeller was damaged from the heat?//


View more questions Search