 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Briggs stratton problems
24 hp briggs and Stratton commercial turf on this lawn mower. It has compression, air and gas, but it doesn't seem to matter if I pull off one sparkplug wire, if I pull the other one off instead it stalls. The funny thing is it doesn't even seem like it is missing! Any ideas?
|
||||
|
||||
|
I would start the engine and then test each spark plug wire for spark. You could slightly pull the wire from the plug, let it touch the plug and then start. Using pliers retract the wire slightly from the plug and see if there is spark. BTW have you removed both plugs too inspect?
I would start the engine and then test each spark plug wire for spark. You could slightly pull the wire from the plug, let it touch the plug and then start. Using pliers retract the wire slightly from the plug and see if there is spark. BTW have you removed both plugs too inspect? |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
18 hp intek ohv that is blowing white smoke puufs and then starts to run rough(backfire). Change plugs and air cleaner and oil, then runs fine with very little puffs of white smoke. After last time of running rough removed air cleaner and it had quite abit of oil in it. Any ideas as to what this...
I have a 18.5hp briggs opposed cylinder engine. It has started using about twice as much gas to mow. The airfilter is clean when you run it full throttle it seems to flood some and run rough and has lost power and it smokes a little black smoke. But when you run it at an idle or about half throttle...
I have a 18 HP twin cylinder B&S on a riding mower. New 300 CCA battery and new cables but it does not turn over fast enough to start. I did put an RV battery on it and it turned over fine to start. Any ideas?
I have been having problems with my briggs and stratton 12.5hp motor! The carburator keeps getting too much gas into the float reservoir and gas comes out. I recently purchused a brand new carb and installed it but still seam to get too much gas to the carburator when I go to start it. Could it be...
I have a B&S 16.5 that will only run at Idle and at Full Choke-I removed the carb and checked and cleaned the jets. When advanced above idle it backfires out the exhaust. And then shuts down. It will restart but only in idle or full choke. Any Ideas?
View more questions Search
|
