 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Pressure switch on inducer motor clicking and shutting down the system...
Model: KG7TC 060D-24B
Gibson/Nordyne Hi All, This problem has been going on for month. I've had 6 HVAC techs come in to check and failed. The pressure switch on the inducer motor is clicking and the furnace shuts down. There is a "poof"... "poof" noise that inducer motor is making and the pressure switch is clicking. We've checked all the drains and seems to be working fine. Nordyne told one of the tech to replace the outlet header box as they have manufacturing fault in older model. Other techs said that's lame. Also, the outlet header box pressure switch is not tripping, it's the once connected to the inducer motor. Any help would be greatly appreciated. Let's see if I can get a solution online... I'm tried of paying 6 techs for not solving my problem. Thanks! |
||||
|
||||
|
Did they show up with an ohmmeter and test the components?
Nordyne Furnace Blower Not Running - Model KG7TC 060D-24B - Repair Parts - RepairClinic.com Nordyne Furnace Starts Then Stops - Model KG7TC 060D-24B - Repair Parts - RepairClinic.com You may also be in line for a failed house calls. Same company sent the techs? |
||||
|
||||
|
Yes, they checked the components and everything was fine. I'm suspecting there is water getting stuff in the inducer motor that's altering the airflow causing "poof-poof" sounds. But when I take the inducer motor off... I only see a little bit of moisture in the back of the outlet header box... nothing major at all.
I've had 3 different companies come in - as after not figuring out the problem and charging money... they stop responding to my call.  Originally Posted by talaniman
|
||||
|
||||
|
I'm trying to follow Nordyne Phone tech support advice and replace the outlet header box... (not that it would do anything). The rubber cement is too stiff and it's not coming off. Any tricks?
Attachment 48211 |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Water pressure high and low... pressure gauge up and down and switch clicking on and off... we replaced the water tank, gauge and pressure switch with no luck.. what is wrong?. could it be the water pump?
My furnace is only 4 yrs old, believe it is high efficiency. This morning it was not working properly. It would start on and right before the flame fired it would shut down. The code was pressure switch open inducer on. I saw that "mygirlsdad77' mentioned there needs to be water in the drain trap...
I have 3 flashes when the furnace shuts off inducer is still running.When it shuts down wait a few min and the furn. Comes back on again.Is this normal operation?I do have a drain opposite side of the inducer.Is that on the wrong side of the furnace.Concord 95.
Hello all. I have a Gibson forced air furnace I've been having trouble with the last couple of days. At first, the unit would start up... Inducer comes on, about 20 sec later the ignition coil starts to glow, the gas would turn on and ignite and it would run for a short period. There is an amber...
I have a new goodman furnace, today furnace will not come on. Blinking light indicates pressure switch indicates open fault and motor to inducer assembly is warm
View more questions Search
|
