 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Shower mixer low pressure
Hi
I had an over bath shower installed upstairs in my house. At the time I had a low pressure water tank. I later had a mains (high) pressure tank installed. Now the shower only runs hot water. Could this be fixed with the installation of a new shower mixer specifically for mains pressure? If so is this an easy enough job to do? Thanks |
||||
|
||||
|
I would first turn main incoming water to the house OFF, remove the cartridge from shower faucet and turned water ON for few seconds to see if you have cold water coming all the way to that shower. You may have debris inside the body or cartridge itself. Also, some faucets have "stops" ( valves at the rough body ). Cold water valve may be in closed position. If you getting water all the way to the faucet, but not through the faucet, and stop-valve is in open position - than cartridge could be the culprit.
Hope that helps Milo |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I am having problems with the hot water mixer and shower in the bathroom. The pressure on said lines is very low. The cold water taps have normal, good pressure. The hand basin hot water tap has normal pressure. This problem is only with the mixer (hot) and now the shower. The hot water pressure in...
Just replaced a new mixer valve off furnace and now there is low hot water pressure to the bathroom. There is also a hot water tank attached to the system. Any ideas?
Hi am not to sure if am posting on the right thread but ill cut the story short I have a mixer shower and the hot water pressure is low I have spoke to a few people and they say get a water pump
I just installed a single contol tub and shower set by price pfister and when I Turn the water on I am getting cold water and warm water and no hot water what did I do wrong
View more questions Search
|
