 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Heater only works on, on not on auto
Hi I have a Goodman central heater and it works perfect on run but if I put it on auto it blows cold air. The wires on the unit say blue (c) for common, red (r), white (w), green (g). And on the thermostat it has B O G Y W not used R Rc. Please help I'm wasting a lot of electricity.
|
||||
Check out some similar questions!
Water heater stopped working on calspa cs 7000 Control panel 52693 cs7000 There is no voltage to the water heater from output 1/2 on the motherborad... water heat was set to 85 and the heat icon was turned on... on the front panel- water heater is good- was tested and it looks good. ...
I have goodman gmp075-3 furnace. I replaced the blower motor, blower wheel, capacitor, and the circuit board. My wife is pregnant with twins so I have to fix this quick... AC only comes on when the fan is set to on instead of auto... if I put it on auto the blower kicks on but AC outside freezes....
Hi My Kenmore dryer only comes on when it is in the Auto dry plus setting, and then shuts off after ten of 15 minutes. When it shuts off it can be restarted right away by resetting the dial. It's a 90 plus series model 78942892. Thanks for any help. RCJ
AC problem. My blower fan will not run in auto. (heater runs in auto fine). The fan will run in "on" position. I suspect the timer (or maybe a limit switch if there is one) on the fan control board. Does anyone know where I can get a schematic for the Lennox BCC2 fan control board? Thanks...
My heating unit works. You can hear and smell the gas fire. However, when switched to Auto on the Thermostat the fan will not kick-in. I can switch the fan to Fan not Auto and the fan runs. When I have the Heat and Auto switched on the Fan does not run. When I set the Thermostat to AC and...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
