Ask Experts Questions for FREE Help !
Ask
    Heerydiane's Avatar
    Heerydiane Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 7, 2015, 02:09 PM
    We have a york diamond 80 gas furnace - no heat
    We have a york diamond 80 gas furnace that is calling for heat, blower works, but no heat or flame comes on.
    Does this have a pilot ?
    Can't find one, if there is
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jan 7, 2015, 03:37 PM
    Unless it is very old, no pilot. If there is a control board, no pilot. There are no flash codes on the control board?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York diamond 90 gas furnace [ 5 Answers ]

Furnace code in 3 pressure switch stuck open should I replace switch

York diamond 80 gas furnace heats but blower stays on continuously [ 5 Answers ]

York Diamond 80 mid efficiency gas furnace. Has worked OK up to last night. Main blower will not shut off, it runs continuously. When heat is called for, all works well. When set temp is reached, gas shuts off, but blower continues. I removed blower door, blower turns off via the door switch. ...

York Diamond 80 Gas furnace (main blower stopped in 2 minutes and never come back) [ 2 Answers ]

I inspected the furnace and found it starts normally (frame, main blower, another motor on top of furnace... etc.) initial time but main blower stopped after 2 -3 minutes even though frame (fire) is on. Frame went out 1-2 minutes after main blower stopped. Frame is continuing to on and off but...

My York Diamond 80 furnace stopped blowing heat [ 1 Answers ]

Hello my furnace stop blowing hot air, and there is no flame. Flashing code 4 for limit switch. Does any one know where it is and how to test. Any help would be appreciated, Thank you.

View more questions Search