 |
|
|
 |
New Member
|
|
Dec 26, 2014, 02:12 PM
|
|
2002 Mazda tribute won't start sometimes
I have a 2002 Mazda Tribute and at times it won't start, I have changed the fuel pump and filter still having the same problem. Not throwing any codes.
|
|
 |
Uber Member
|
|
Dec 26, 2014, 02:40 PM
|
|
Have you gone over the ignition system and replaced spark plugs, wires, coil, and crankshaft position sensor? All of these items take a beating. If the problem persists, try to "force" a code by keep trying to start the engine when it doesn't want to. It may then throw a code and give you a "tell" on where the problem is. Also, try starting the engine by slightly depressing the gas pedal. If the Idle Air Control Valve (IACV) is staying shut, the engine may be starved for air. Depressing the gas pedal slightly may help you identify a bad IACV, which is normally super easy to replace (go OEM).
|
|
 |
New Member
|
|
Dec 28, 2014, 11:00 AM
|
|
When it won't start you can't hear the fuel pump coming on?
|
|
 |
Uber Member
|
|
Dec 28, 2014, 11:24 AM
|
|
. Check/replace the fuel pump relay, if your Mazda has one.
. Remove and clean the contacts going to the fuel pump fuse in the under hood fuse/relay box.
. Check the ignition switch for wear, pitting, or melting, if the problem persists.
When the fuel pump doesn't run, does the check engine light come on and go off normally, when the ignition switch is turned to ON?
|
|
 |
New Member
|
|
Dec 28, 2014, 12:09 PM
|
|
Yeah everything lights up then back off. Doesn't throw any codes either.
It does have a fuel pump relay replaced it with one of the other relays still nothing
|
|
 |
Uber Member
|
|
Dec 28, 2014, 04:06 PM
|
|
Thoughts:
See if your Mazda has a Constant Control Relay Module (CCRM), which are often located next to the battery on Fords. Since Ford used to own a third of Mazda, the technology is often similar. This is a complex module, if your vehicle has one, and you would need to find out how to test the CCRM's fuel pump relay. You may need to refer to a fuel system wiring diagram in a Haynes Manual. Also, reset the inertia switch, if your Mazda has one.
|
|
 |
Uber Member
|
|
Dec 29, 2014, 07:48 AM
|
|
Check and clean all grounds (battery to transmission, battery to fender, firewall to engine, and any others), connectors, and wiring.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
2001 Mazda Tribute runs fine, then unexpectedly won't start (acts flooded)
[ 25 Answers ]
Hello,
I'm looking for some help with troubleshooting an intermittent problem we're having with our 2001 Mazda Tribute:
The car will run just fine, then out of the blue we'll get stranded somewhere when we make a stop. The car cranks and sounds like it will start... but behaves as if it is...
2001 mazda tribute won't start
[ 2 Answers ]
I have a 2001 mazda tribute that won't start we checked the spark and fuel pump they are fine but for some reason it won't start
2003 mazda tribute won't start
[ 10 Answers ]
I have a 2003 Mazda Tribute 2wd v6. When I turn the key the gauges kick on but the fuel pump doesn't and the key will not crank the starter. I can jump the starter but since the fuel pump doesn't kick on obviously it won't start. I checked the starter relay and fuel pump relay both fine. I also...
03 mazda tribute won't start.power every where
[ 0 Answers ]
Hey... my 03 mazda tribute is having issues... it went from occasionally not starting... to not starting at all... power inside... if I jump starter... it will turn fine... but not fire. Replaced... starter... ignition mod inside. Steer column... nothing... was told it may be in P A T circuit......
View more questions
Search
|