Ask Experts Questions for FREE Help !
Ask
    gdwylie's Avatar
    gdwylie Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 17, 2014, 02:09 PM
    E3 error on Bryant HVAC controllers
    'E3' periodically displayed on Bryant automatic controller for my HVAC. What error does this indicate? How do I reset it?
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
    		  
    #2

    Nov 17, 2014, 03:57 PM
    What's the model number? The codes should be on the inside of the cover.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have two BRYANT hvac units. 1075 rpms, 2000 model year [ 0 Answers ]

I changed the motor on one of them the other day, at first it wasn't cold, I was told it takes awhile, then the next day, it started getting cold, but now its blowing warm air. And now the downstairs unit has decided to quit blowing air altogether. I noticed a frost on the copper tubing outside, so...

How to turn continuous fan off on a bryant 330 gas hvac [ 0 Answers ]

Cannot pull-out the blower wheel and motor assy from a Bryant HVAC [ 13 Answers ]

The blower wheel has a larger diameter than the opening of the air chamber. The blower wheel is damaged. Something inside the unit caused four of the vanes of the blower wheel to break off and jam the motor. This is a Bryant HVAC built in 2006. Has anyone else had this problem with an internal part...

Bryant Plus 80 error 33 [ 3 Answers ]

Good Afternoon; I need some help to understand why I'm getting the error, and what I can do to fix it. Its -38 degrees C outside and the furnace is working really hard to keep up... but is unable to do so. Its shutting down the flame constantly... the temperature in the house has dropped to...

Bryant Rooftop hvac unit not cycling properly [ 1 Answers ]

I Have an older Bryant 6-ton rooftop unit model 580c that will run for a few minutes... shut off but will NOT "cycle" back on for heat. You would have to "re-set" by powering off/on at the breaker panel. I am getting a "CODE #6 Inducer Motor Fault" even though motor seems to be functioning OK. It...

View more questions Search