Ask Experts Questions for FREE Help !
Ask
    jeff85jon26's Avatar
    jeff85jon26 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 31, 2014, 06:13 PM
    Burners for XL 1100 Trane furnace?
    How do you clean gas burners for XL 1100 Trane furnace? Also I read where the flame rollout switch showing open is symptomatic of a furnace drafting problem. Exactly what does that mean?
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
    		  
    #2

    Nov 1, 2014, 09:43 AM
    The roll out switch will tell you that you might have a blockage in your vent pipes. Also tells you the heat exchanger might be bad. Take a look at the flames and see if they are "dancing" or steady.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane XB80 gas furnace, no burners, four flashing leds, won't reset [ 2 Answers ]

I have a Trane XB80 gas furnace and the fan works but the burners don't even try to come on. I had a similar problem last year and the tech came out and found an improperly installed filter that was clogged. After removing the filter, he restarted the furnace. It worked for a couple of days, then...

Trane XE80 furnace. Blower stays on. Burners ignite, then turn off. This is continuou [ 11 Answers ]

I have a Trane xe80 furnace. Last night I noticed the blower wasn't shutting off. I reset the thermostat. The blower stays on and the burners ignite for 2 seconds and turn off. This repeats over and over. Can anyone help with this, as it is very cold in Missouri right now. Also the red light...

Trane XL-1100 [ 3 Answers ]

My unit will run one heating cycle, achieve the desired temp and kick off. When the thermostat calls for the next cycle it will fire up and blow heat for maybe one minute or not at all! I will then have to turn off the thermostat several times and back to heat to make it come on. I replaced the...

Furnace burners ignite but won't stay lit on my trane xe78 furnace? [ 0 Answers ]

I have a Trane XE78 furnace and the flames come on for about 5-10 seconds and then shut off. They re-ignite about 10 seconds later, then shut off 5-10 seconds after the 2nd ignition. I believe they flame on one more time, shut off and then never re-ignite and the blower just runs and runs with...

Trane furnace blower doesn't come on, compressor on heat burners ignite, new stat [ 6 Answers ]

Blower won't run, even in on mode, replaced stat, still nothing, has power to motor, can turn cage freely, furnace led light says system normal, compressor for air comes on, heat ignites, just no fan blower, any ideas

View more questions Search