Ask Experts Questions for FREE Help !
Ask
    farleyredfield's Avatar
    farleyredfield Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 28, 2014, 07:05 PM
    Trouble Shooting a White Rogers 50A50-112
    I have a White Rogers 50A50-112 (general 90) control board. The flame will lite all across the burners (4) when the flame touches the sensor and sensor is connected the board kills the combustion blower and ignitor.
    If I leave the sensor unplugged the flame will still lite and the flame will touch the ignitor and the flame will stay on until the ignitor turns over to flame sensing then turns off the flame only and the combustion blower continues to run.

    I have added a ground wire for the burner, but it changed nothing.

    The whole thing seems to be tied to the board its self but no codes show up and the time off is about 1 minute then restarts another heating cycle.

    Ideas?
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Oct 29, 2014, 08:55 AM
    If the flame sensor is a separate probe from the ignitor, remove the sensor & clean the metal probe with a Scotch Brite pad or fine steel wool. Re-install & try the furnace again. The fact it is not throwing a code makes me think the control is bad but cleaning the probe is easy & might fix the problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trouble shooting ICP white rogers 50a50-112 furnace control red light code [ 2 Answers ]

I have a white roger ICP 50a50-112 control board that gives me 3 flashes

White-rogers 50a50-241 [ 0 Answers ]

Humidifier aprilaire 760 do not work. Do not want open valve and humidifier fan do not start. Valve is OK.

White rogers 50A50-471 and -473 [ 5 Answers ]

My furnace flame goes out at times. Sometimes it won't light, other times it lights and quits after a few seconds or almost a minute. Then it might run for many minutes. One time I got a steady LED indicator light, controller needs replacement. Then it works again. I have the White Rogers...

White rogers 50A50-471 [ 0 Answers ]

I can't reply through the web page it just redirects me to register and says my username is already being used... so I re applied with a new user name My Original Question: My furnace flame goes out at times. Sometimes it won't light, other times it lights and quits after a few seconds or...

White rogers 50a50-241 [ 1 Answers ]

I get lockouts about every two weeks and have to clean the sensor again .Bad board?

View more questions Search