Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Black wire red wire and white wire spliced to 10/3 on a 220 circuit
[ 25 Answers ]
I have installed a disconnect between my dryer receptable and a tanning bed. I want to splice the 10/3 box wire to the existing 220 wiring at the dryer. Dryer= red, black, white and bare ground wires 10/3 wire= black, white, and bare ground How do I splice these to allow the disconnect box to...
How can I use an older 3 wire 220 circuit for a 4 wire hot tub
[ 6 Answers ]
Can I somehow use an existing 3 wire 220 volt circuit to power a 4 wire hot tub? Running a new 4 wire circuit back to the main panel will be long and difficult. I have nearby access to an old 3 wire sub panel once used for an air conditioner. This original circuit is missng the ground wire.
Direct Wire Smoke Detectors
[ 1 Answers ]
Last night we had a smoke detector activation in the middle of the night. No smoke was detected anywhere in the house. The dectectors are direct wire. Does anyone have any ideas what could cause the detectors to activate other than smoke? Some factors to consider... The detectors are 13...
How to wire 2 wire fan remote to 3 wire circuit?
[ 10 Answers ]
I have a room that has 2 light switchs to the same light, so it is a 3 wire circuit. I bought a fan with a remote and the wall mounted remote has only 2 wires, how can I connect it? Thanks, Pete
Physics and Motion Detectors
[ 1 Answers ]
I am doing a school project on the physics behind motion detectors. I have done some research but only found some info on "Smart detectors." Can anyone help me?? I have ordered a motion detector kit, and must put it together, but I also am required to know the science behind motion detection... View more questions Search
|