 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
There is no industry standard. You can place them where you want. Typically the knobs are 3-4" below the unhinged corner of a base or and 3-4 inches above the unhinged corner of a wall cabinet and the pulls are centered on the drawer. You can buy templates at HD or Lowe's that have pre drilled holes. Check the Amerock website for more mounting info.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hi -- I'm removing a bottom kitchen cabinet in order to install a dishwasher. I CAN'T get the cabinet out. (It has seams between each cabinet that run from under the countertop through to the floor, so it should be modular.) I removed the doors and shelves, and every screw that is apparent....
Hello everyone, We are remodeling our kitchen. We've gotten through most of the tricky electrical work and have started installing cabinets. We are soon to start installing the trickiest cabinet - the sink cabinet. Hopefully these images come through. The drain column is going to be...
Installing a cabinet door on a bosch dishwasher
I also had a similar problem and through my investigation I found that when the home was built, the plumber stubbed in a clean-out during construction, but did not finish it through the wall to the outside. When the brick was applied the 2" PVC clean out rough-in was covered up with plywood. This...
I bought two sets of touch sensitive under cabinet kitchen light set put them in but one set keeps flashing then stops all together I've replaced the transformer and the touch switch but the wires in the six port connector, when you move the wires there the light go out two which one you touch ....
View more questions Search
|
