Ask Experts Questions for FREE Help !
Ask
    smclynn's Avatar
    smclynn Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 24, 2014, 10:20 AM
    Is a al/cu wire connector the same as an aluminum splicer/reducer (Morris)
    Alum. Wire in condo- - stove has copper wire - when changing stove see blue wire nuts... No good. Went to electric supply and they sold me Morris esr250s Aluminum splicers/reducers said better than the wire nuts?. said need to tape up and put back in box... are these OK?. neighbor was questioning them.

    Thanks Steve
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    May 24, 2014, 04:14 PM
    Go to the Morris website. Claim the spicer products are ANSI approved for AL-AL or AL-CU connections.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to wire a 3 aluminum wire to a 4 wire 220 cook top [ 3 Answers ]

I have a older home with Alum. Wiring. I'm want to hook-up a new 220 cook top. My service line is 3 line, two insulated and one bare strand ground. The cook top has 4 wires Blk,Red,Wht, & Grn. Do I connect the Red and Blk (hot) one each to the two lines fron the servive panel and then connect the...

Hunter 44905 Thermostat ground wire connector- where do the wire go [ 0 Answers ]

Just bought hunter 44905 thermostat and the wires that goes to the old one include the ground wire.where do this wire go on my new hunter 44905 thermostat connector? Thanks

Aluminum main panel to copper sub panel with aluminum wire? [ 7 Answers ]

I am upgrading branch wires in a house from aluminum to copper. Replacing all boxes... switch/outlet/receptacle/lighting, etc.. The house currently has a main panel (or lug not sure which.. maybe lug because there is no "main" breaker) next to the meter. The main panel is aluminum rated and has...

How to safely wire aluminum to copper wire [ 5 Answers ]

I am switching a non-programmable t-stat to a Honeywell 5-2day programmable one that is for baseboard, covectors and fan-forced heaters. The model number is RLV430A. I have a wall Cadet heater so it should be OK. Problem is when I opened the package the wiring on the t-stat is aluminum. ...

View more questions Search