Ask Experts Questions for FREE Help !
Ask
    d1holland's Avatar
    d1holland Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 20, 2014, 06:35 PM
    Problem with automatic governor on 6.0 craftsman eager -1
    I have a horizontal governor on a craftsman eager-1 6.0 hp engine and it either runs wide open or closed. How do I adjust it?
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    May 24, 2014, 07:43 AM
    Hi,
    Since you say it is an Eager 1, then I gather it is an older Tecumseh engine. A link to get the manual on the older L-head Tecumseh engines is:
    http://www.smallenginesuppliers.com/...nformation.pdf
    It is a bit over 5 MB and requires Adobe Acrobat Reader.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman Eager-1 carbs [ 3 Answers ]

My mower was having trouble staying running. The guy that gave it to me said that it sat for about four years. He had it worked on by some one and they got it to run but it still wasn't right.After he gave to me I removed the carb, cleaned all the guk out. Now I am ready to remount it. Problem is...

Carburetor Schematic (Craftsman Eager-1 Mower) [ 1 Answers ]

I have a Craftsman Eager-1 Mower (mdl.9173827.11) I installed a new carburetor and have apparently gotten crossed up on the hookup of the governor. It starts without effort but runs very slow. Can anyone send me a schematic on the correct hookup of the governor and the carb linkage? Thanks

Craftsman Eager-1 push mower [ 4 Answers ]

Craftsman Eager-1 push mower is cranking, runs for a little then shuts off. What cause this? I have replaced the spark plug. Where do I go from there?

Craftsman Eager 1 Fuel Filter [ 1 Answers ]

My craftsman eager 1 lawn mower will not stay cranked. I have changed the spark plug. One answer suggested that the fuel filter might be clogged. Where is the fuel filter and how do I change it or by pass it?

Carburetor settings on Craftsman Eager-1? [ 1 Answers ]

Does anyone have a Craftsman Eager-1 lawn mower. I disassembled the carburetor and I can't remember the settings for the throttle and governor switch. Now it runs but is continually dying until I reprime and start back up. UGHH! You don't need to know anything about the carb.. . Just a picture...

View more questions Search