 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Blower keeps running after cycle is complete. At beginning of heating season replaced thermostat batteries and ran good since. Six months later doing it again and new batteries didn't help. Cleaned flame sensor. Error code 8 red flashes. Igniter looks like it could be worn down or broke off in...
I have an older Luxair gas furnace the furnace works fine heats up the temperature but once it reaches the temperature and the heat turns off the blower continues to run. I have checked all belts and look for debris in the blower but again the blower is working fine it just does not shut off I have...
Hello. I have a three year old Luxaire Central Air Conditioner - ACCLIMATE - Model# AL3A036F1A with a YORK Air Handler Model# N4AHD14A06A. It is connected to a White-Rodgers thermostat Model# 1F90-71 (transformer = 24VAC secondary voltage)which is also connected to a hot water base board heatings...
An a/c co. had installed in my house & garage AMANA 16.7 seer a/c. 4 T cond. 2 speed M# RSG48C2A, Ultron R-410. 95% variable speed AMV90704CXA furn. And 5 T evap. CH60FCA. House 1,530 & garage 462. City inspector req'd all supplies removed from garage before approving permit. I have a...
My Luxaire furnace (installed in 2005) shows a red light that flashes 3 times. The symptom is that no air will blow out of the furnace, even though the unit makes a humming sound like it wants to kick on.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
