[Steve5858]

What type and size of water pipe should be run for a length of 650 feet to house from meter?

[ma0641]

What size is the meter?

[Steve5858]

I think the outlet is 5/8.I would need to check with the utility for sure.

[catonsville]

I had the contractor install 1" Copper from the road to the Meter in the house a distance of approx. 200 feet. Wanted to make sure I had plenty of water.

[ma0641]

5/8 is pretty small for that distance. I think you would be disappointed in the volume. A 1" meter and PVC or Polyethylene would be more appropriate. A lot depends on what the utility will install. Putting a 1" line on a 5/8(3/4?) meter serves no purpose.

[speedball1]

I would increase the meter to at least 1" (1 1 1/4 would be better) And run plastic the same size as the meter. I notice the street PSI hasn't been mentioned. It's going to take a lot more pressure to push the water in th supply line 650n feet, (is any part of the line running uphill?) the conventual 45 PSI mot houses get from the street. Get with your water company and let them know your situation, Good luck, Tom

[massplumber2008]

Hi Steve

As you know, water pressure is determined by what your water department supplies...it is basically a small range of pressure depending on peak use or disuse in your area. If you do not like the pressure that arrives at your home you can always install a booster pump to increase the pressure so that it is right for you and your family.

In terms of volume/size of water pipe needed, we would need to know the exact number of toilets, showers, tubs, sinks, laundry sinks, washing machines, jacuzzis, dishwashers, ice makers, outside faucets, water heater(s) and size(s), and if you are planning on an exterior pool, an irrigation/sprinkler system (number of heads and or square feet of yard to be covered needed), an exterior pond, or any future expansion that you think might happen to the property over time, etc...that kind of stuff, and then and only then can we come close to tell you what size pipe you need for your home water main!

If you provided all that information we might be able to come close, but we could still be off as different states size main water piping at different values, so you really are best to consult the local water department and the local building inspector and/or an engineer and figure this out for you as it is a small issue now, but a super big issue if it is found to be undersized later! Armed with the proper water main sizing as required for your residence by an engineer/plumber/inspector almost guarantees that the water department will have no argument when time for the final meter installation!!

Good luck!

Mark