Ask Experts Questions for FREE Help !
Ask
    Howard2014's Avatar
    Howard2014 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 27, 2014, 08:26 AM
    Trouble shooting for Bryant furnace 80 Plus
    We've got a Bryant 80 Plus furnace gas stopped working yesterday. Can not read the code since the thermostate was dark and not working as well. The only things we found was the red light on the furnace was flashing and the fan kept blowing cool air into the house. How do we know which one cause the problem? The thermostate or the furnace?

    Thank you in advance for your suggestions.
    Hv
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Mar 28, 2014, 07:04 PM
    Look on the inside of the blower door or on the control itself for a key to the blink code. Let us know the result & we can likely help you track down the source of the trouble.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace trouble shooting [ 3 Answers ]

I have a Goodman GMPN060-3 gas furnace. My ignitor will glow and ignite the burner but will go out in just a few seconds. I have replaced the ignitor but still have the same problem. The furnace will try to ignite three times before shutting down. Sometimes it will ignite and continue burning on...

Intertherm Furnace Trouble Shooting [ 0 Answers ]

I have an Intertherm Nat. gas furnace,. Model # MMHA - 056 - AAHR -05. The small vertical Booster motor (Cumbustion Blower Motor ) runs constantly. The Thermostat can be set at 80 deg... and the actual room temp. will get no more than 62 deg. The blower ( fan ) motor works fine coming on, and...

Trouble shooting a clare furnace [ 1 Answers ]

My clare furnace will not come on. When I turn the furnace on noting happens. But if I turn the main fan switch on it comes on. But when I turn the thermostat up the small fan doesn't come on which in turn will not let the furnace work

Trouble shooting furnace [ 3 Answers ]

Hello I have a Altra 90 SX Armstrong furnace that has a cycle problem. The model # is a GUK75D103A with a Heatcraft control board 404030001 Cat. # 70K98 The problem that I'm actually having is that it is going through its cycles OK, except the induced fan keeps running and won't shut off. ...

Furnace Trouble shooting [ 1 Answers ]

I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...

View more questions Search