 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Symmons model a temptrol doesn't switch from shower to tub anymore
Hello, I have a symmons model a temptrol shower valve. The spindle doesn't switch from shower to tub and vice versa. The spindle also pulls out from the fixture. Any advice? Thanks in advance.
Dave |
||||
|
||||
|
Hi Dave.
I know the valve real well and you have a defective spindle handle or a defective spindle cartridge...or both! At this point, you are probably best to purchase a new trim kit from home depot or lowes. I suggest the ALLURA series trim kit as it is an upgrade over the traditional trim kit (see image). This kit will include all new trim and a new spindle handle. Now, to remove the spindle assembly (see image) is not easy...even by plumbers' standards. Here, Symmons themselves recommend a 5/16" lag bolt to remove the spindle. You'll usually need an allen-wrench (1/4" if I remember correctly) to remove a retainer nut (not shown), but it could also be a retainer plate held in by two screws, and then you screw the lag bolt into the diverter spindle about a 1/4 to 1/2" and then, believe it or not, you YANK the spindle out by the lag bolt!!! Be warned, it doesn't always come out easily! Think on this and then post back. Removing a stuck spindle is hard, but not impossible, and this valve is worth saving, I promise! Mark |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hello, I purchased a TA-10 to replace the spindle in my Symmons '76 Temptrol Model A. After removing the original spindle I notice that the replacement part is different. Namely, there is no thread on the largest circumference part on the replacement part whereas the original has a thread....
I have a Symmons Temptrol tub and bath faucet which is leaking at the handle. It is 20 years old and I suspect that the cartridge needs replacing. Do I remove the handle first and then the plate which is held by two screws? Where is the cartridge located? Is there some literature that will...
I can only get hot water from this brand new valve. Yhe only way to get cooler water is to reduce the valve to a point where I get very low flow. Increasing the flow to a satisfactory flow only gives hot water. The water coming in is at 130 degrees F. I can not change the temp of the water coming...
I printed off the internet the part breakdwon to my tub/shower one-dial Symmons Temtrol kit as I am trying to stop a slow leak out oif the tub faucet. I removed the screw and cap - and I can't get the handle off - is it hyst suppoosed to pull off once the screw is removed? That is how the...
View more questions Search
|
