Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Furnace replacement recommendation for Day & Night model #100U-19A, 100,000 BTU
[ 1 Answers ]
Home built in 1975 with DAY & NIGHT furnace model #100U-19A, Input: 100,000 BTU/hr, Bonnet Capacity: 80,000 BTU/hr. Since original construction, 2 rooms added for total square footage at 2,650. Old furnace has rust spots. Expect holes to form soon. Must replace furnace now.
Day&Night 80U-19A inop
[ 0 Answers ]
Hi, I have an 80U-19A that will not light the burner and has no fan operation. The previous owner installed a Honeywell low-voltage programmable thermostat (4-wire) to the furnace, connecting only the red and white wires (only two are in the unit diagram because it is not an air conditioned unit)....
Using ceiling fan regulator for table fan regulator
[ 0 Answers ]
Hey can I use my ceiling fan switch regulator that gives continuous regulation instead of steps which traditional regulators used to give , in my table fan regulation which also has three speeds to get continuous speed regulation?
Day and night model 80u-19a burners on but blowers kick on and off
[ 0 Answers ]
I have a Day and Night model 80U-19a Furnace. The blower is kicking on and off while the burners are still on every 20-30 seconds. It doesn't run constantly until the thermostat reach the necessary temperature. What do you think is bad? Fan relay switch? I have replaced the thermostat, check the...
Lighting the pilot light on a payne 125u-19a
[ 2 Answers ]
I need to light the pilot on a payne model 125u-19a. I can find the pilot/on, but cannot figure out where the pilot nipple is inside the furnace. Can you direct me? View more questions Search
|