 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Pressure drop from cold water tap.
Hi - I live in a new building. I seem to have decent water pressure from the hot tap, but less from the cold tap. The gauge in the upstairs airing cupboard shows bar at 3 but psi as 0. I've checked the stop tap downstairs and it's fully open.
I also have an issue where turning on a tap drains water from the others, especially when flushing a toilet. |
||||
Check out some similar questions!
Hi there Looking for a formula for pressure testing with water. Think there is one where you have a known test volume(aleadt filled with water) I have start pressure and end pressure but trying to find a formula to give the voloume of water that would have to be added to the closed system to...
Good hot and cold water pressure at faucet but when switched to shower, temperature of water drops drastically (minimal hot water coming through) and water pressure is very low. Shower head has been switched, mesh has been cleaned of any debris, and black rubber ring has been changed. What can I...
Low water pressure copper pipe low at all fixtures and faucets. City has checked pressure. They installed new shutoff in streetalso. They checked meter and was OK. I am orignal owner feed from street is 3/4".copper house also. House built in 1972. Problem started 6 months ago. I am at whits...
My 40/60 3/4hp shallow well jet pump will run continuously and will not build up air pressure in the bladder. The bladder will hold pressure though. I have filled it with air and when I turn on the water it loses its pressure and when the pump kicks on it just keeps running without building the...
When the yellow jacket brand gauges are put on a 3 ton Tempstar heat pump what should the correct suction pressure and head pressure be. I suspect it to be overcharged in freon. Because it is freezing the compressor, accumulator tank and all the lines soild ice.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
