Ask Experts Questions for FREE Help !
Ask
    Superdon's Avatar
    Superdon Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 16, 2014, 09:43 AM
    Can I use conduit to tie communication cable to in my factory
    We want tie comm cable to the conduit in our building .and some said it was not up to code.Is this true?
    hfcarson's Avatar
    hfcarson Posts: 1,003, Reputation: 49
    Ultra Member
    		  
    #2

    Jan 16, 2014, 09:55 AM
    I agree
    ebaines's Avatar
    ebaines Posts: 12,131, Reputation: 1307
    Expert
    		  
    #3

    Jan 16, 2014, 10:06 AM
    It sounds like you're planning on what's called "non-continuous support" as opposed to using cable trays or conduit for the comunications cables. According to standard TIA/EIA-569, "Commercial Building Standard for Telecommunications Pathways and Spaces," communications cables must be supported in one of three ways: by cantilever brackets from a wall, trapeze or individual rod supports from the ceiling, or directly from the floor. In addition, "rods or wires that are currently employed for other functions (e.g. suspended ceiling grid support) shall not be utilized as attachment points for non-continuous support.

    If you're planning a new installation or retrofit I suggest that you hire a consultant and/or installer who is RCDD-qualified (Registered Communications Distribition Designer) by the Buildings Industry Consulting Service International (BICSI). This ensures that proper methods are followed.
    hfcarson's Avatar
    hfcarson Posts: 1,003, Reputation: 49
    Ultra Member
    		  
    #4

    Jan 16, 2014, 11:23 AM
    e... nicely stated!
    I can't quote any specific code on this one but I would add that other rules such as laying cables on suspended ceilings and the like will be flagged by a Building Sub Code Official...
    Aside from the code just attempting good workman like installation practices would argue against the fast and easy solutions like ty-raps and conduits.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can ser cable be installed in pvc conduit [ 3 Answers ]

Can ser cable run underground in rigid pvc conduit

Can telephone cable and television cable put in one electrical conduit [ 5 Answers ]

Can telephone cable and television cable put in one electrical conduit?

N.E.C. Entrance cable and conduit [ 1 Answers ]

I need to install a new residential service on my house. Small mishap with a tree this past weekend. Does code specify that my entrance cable must be in conduit since there is a side walk on the same side as the service? If so what is the minimum size plastic conduit I need to use for a 100 amp...

Conduit size for MHF cable [ 5 Answers ]

Hi -- What is the proper conduit size for installing 4/0-4/0-4/0-2/0 Mobile Home Feeder cable? The meter box is on a pole about 25 feet from the house. The cable is rated for direct burial, but I think I should run the whole way in conduit because of the rocky soil.

Cable/conduit lubricant for pulling new cable? [ 1 Answers ]

What is recommended lubricant for pulling cable through conduit?

View more questions Search