Ask Experts Questions for FREE Help !
Ask
    gmurray's Avatar
    gmurray Posts: 4, Reputation: 1
    New Member
     
    #1

    Dec 13, 2013, 02:17 PM
    Concord 90 plus high efficiency gas furnace ignition failure
    My 12 yr old concord 90 plus when it shuts down after temp is reached ,with the blower still blowing will re-ignite,run for 30 secs then shut off, re- ignite again for 30 secs again and does this about 6 times before it finally shuts down. Then it will not come back on after temp drops, then I get 6 flashes on the gas valve, I shut off the gas valve, shut off the gas, then switch of the power wait 15 minutes then turn on the gas.valve and the power then it starts and runs for 1, 2 maybe 3 hours then goes through then process again, What might cause this to happen, It ran great when I turn the heat on in the fall,until it gets cold then it starts to act up again. sometimes it starts the same way,ignites for 30secs then shuts off , ignites again 4or 5 times, then it shuts down and goes into lockout.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    Dec 13, 2013, 03:34 PM
    Make sure your intake and exhaust vent are not restricted, I had a wasp nest in mine. Also polish the flame sensor with steel wool or 400 grit wet or dry.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Concord 90 plus high efficiency gas furnace [ 0 Answers ]

How can I access the AC coils on the inside of furnace to clean them?

Concord high efficiency gas furnace [ 0 Answers ]

When the temperature was high in the past days, I noticed that Air conditioner takes a long time to cool. The AC is working. How do I check if the fan is working ?

Concord 90 plus high efficiency furnace? [ 0 Answers ]

Our heater broke and I was wondering where can I get the Honeywell gas valve VR8205S2346 or is there another model that would fit for our heater?

Concord 90 plus high efficiency gas furnace 6 light blinks [ 1 Answers ]

The furnace starts up, ignights runs a little just before the blower would start, it resets it's self and starts over the process. I counted 6 light blinks and that's all it does, over and over... What is wrong? Please help! Thanks

Concord 90 plus high efficiency furnace [ 12 Answers ]

For past few days home temperature drops down approx 6-7C degrees at night so I checked the furnace which gives me sometimes (6) LED signals other times (3) LED signals. I followed the back panel instructions also drain out water from tube connecting to motor and restart, however each time it lasts...


View more questions Search