Janitrol Furnace Problem Answers

harmoney27 Posts: 2, Reputation: 1

New Member

Dec 4, 2013, 09:51 AM

Janitrol Furnace Problem Answers

The burners go on but shut right off

harmoney27 Posts: 2, Reputation: 1

New Member

Dec 4, 2013, 09:53 AM

Burners don't stay on

ma0641 Posts: 15,675, Reputation: 1012

Uber Member

Dec 4, 2013, 10:43 AM

Roll out switch, flame sensor or other safety limit switch would be a place to start.

Add your answer here.

Check out some similar questions!

Janitrol blower relay problem [ 7 Answers ]

I have a Janitrol GMP075-3 furnace and the blower will constantly run unless I turn the power off to the furnace. I believe the problem is from the blower relay because the a/c turns on and shuts off when commanded. I looked at the circuit board in the furnace and I could not tell where the...

Janitrol furnace [ 1 Answers ]

I have a janitrol furnace serial # 6491074 size UA585-14. We have to push in and hold the (ignitor?Pilot?) button for several minutes before it will stay lit. Then it seems after it runs for a bit, the pilot light is still lit, and the fan is still running, but it won't blow warm air anymore. What...

Problem with my Janitrol Furnace [ 1 Answers ]

Everything starts up fine but the heat shuts down after a couple minutes.Not sure what the problem is.Can anyone HELP?

Janitrol furnace [ 5 Answers ]

I hit the power on my furnace and the board hums for a few seconds and then blinks three times . Ihave checked for blockage in vent and is fine. Ihave blowed pressure switch and it clicks is it the switch board or air blower that won't start.

Janitrol furnace [ 4 Answers ]

I have to down to the basement and manuel turn the blower on it will not go on on auto only manuel what do you think is wrong thanks tboy56