 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Janitrol furnace
I have a janitrol furnace serial # 6491074 size UA585-14. We have to push in and hold the (ignitor?Pilot?) button for several minutes before it will stay lit. Then it seems after it runs for a bit, the pilot light is still lit, and the fan is still running, but it won't blow warm air anymore. What could be the problem? Someone suggested the thermocouple, but someone else just said that can't be the problem since the pilot light is still lit. A gas valve, maybe?
|
||||
|
||||
|
Need to know exatly if this unit has a thermocouple, or a powerpile. If thermocouple, then the couple is not the problem, as your friend said, if you have a bad thermocouple, the pilot will not stay lit. However, if it is a powerpile, it may be producing just enough energy to keep the pilot lit, but not enough to kick the gas valve on, or keep it on.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Everything starts up fine but the heat shuts down after a couple minutes.Not sure what the problem is.Can anyone HELP?
I hit the power on my furnace and the board hums for a few seconds and then blinks three times . Ihave checked for blockage in vent and is fine. Ihave blowed pressure switch and it clicks is it the switch board or air blower that won't start.
Hello - I have a Janitrol Model # GUE060-E Furnace. The blower will not shut off unless I power it off by removing the bottom panel. I hear a clicking sound like it wants to shut off. The thermostat is set to auto mode. Could it be the relay? Thanks, Dan
I have to down to the basement and manuel turn the blower on it will not go on on auto only manuel what do you think is wrong thanks tboy56
View more questions Search
|
