Ask Experts Questions for FREE Help !
Ask
    Stephen Haithco's Avatar
    Stephen Haithco Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 27, 2013, 09:20 AM
    The roll out switch is tripping on my Rheem furnace.
    The original roll out switch fell apart.I put in a new one and it still is tripping off .Doesn't when side cover is off.Heat exchanger and burner manifolds were replaced 3 years ago.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Nov 27, 2013, 05:13 PM
    If the switch doesn't trip with the cover off but does otherwise, it would seem you have a combustion air problem. What exactly do you mean by "side cover"?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rheem high pressure switch keeps tripping [ 10 Answers ]

Not sure if I've summarized the issue exactly right, but my downstairs, outside unit keeps switching off the past several days. I will feel air coming out of my registers but it isn't very warm. I have to go outside several times a day to push the red button to fire up the outside unit. Once I do...

York Furnace Roll Out Switch Keeps Tripping [ 1 Answers ]

Hi Everyone -- Any advice is appreciated! My 8 year old York furnace has had a rough season. It began with a high-limit switch that went bad and was replaced. Shortly after being replaced (with the same part number) the roll out switch on top of the burners began intermittently tripping, upon...

Goodman furnace- roll out switch [ 0 Answers ]

Roll out switch needed resetting. My service man says new furnace required. Is it possible that just a new switch could be needed?

Furnace roll out switch [ 1 Answers ]

Can't seem to discover why the roll out switch above the top burner trips after about an hour of heater operation. Unitary Products horizontal propane furnace. Filters are clean, vent is clear. Cabinet near burners not excessively warm. The controller blinks 5 times until the switch is reset. ...

Rheem Criterion thermal switch keeps tripping [ 4 Answers ]

Recurring intermittent problem: Furnace runs properly, but more and more often, the thermal (350 deg) switch above the leftmost burner trips, which causes the blower to stay on and the furnace to NOT re-light when the thermostat calls for another cycle. I can reset the switch (depress the small...

View more questions Search