 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have replaced the exhaust motor and it worked for a few days then it would only blow cold air the exhaust would come on then the blower right away. The baord was replaced then it did the same thing again the last 2 times the error code says open limit
My York diamond 80 gas furnace does not come on and my mother board lights up red 1 time then it just blinks 3 times repeatedly, can anyone help!!
My gas furnace periodically goes to rollout lockout when very cold outside.I wonder if a weak sensor is my culprit.Air flow seams to be a problem at times.the rollout sensors are fine. What to do?
HVAC replaced circuit board on my york gas furnace New board has a green light that flashes continuously on/off about every 1 second When furnace is running this light changes to red and flashes at same rate Is this normal?
York furnace, thermostat calls for heat, hot surface ignitor glows, flame in burner box lights for about 1-3sec and then goes out, already replaced flame sensor, any ideas/
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
