 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
White rodgers control module 50e47-843 only works part time
York furnace with old white Rodgers controller 50E47-070 only sending power to gas valve every so often if power is shut off and turned back on sometimes will fire up Replaced controller with WR 50E47-843 doing the same thing unit don't always send power to gas valve. Any idea what may cause this to happen.
|
||||
Check out some similar questions!
Board died, replaced it with 50a55-843. Put in ro1/ro2 jumper. When I turned it on both the inductor motor and the blower came on. The furance fired up but after 1 minute the blower turned off. It reached high temp limit and shut down. Anybody have any ideas?
I have modual shut down of a w-r 50e47-174 modual I cleaned the flame sensor & it works about 2 days to a week before failing. After turning the power off & back on the unit works fine for a short time. How do you test the flame sensor & what volt output Thanks Theo
This is my first time post. Hello everone Here is my question: I am replacing a Johnson Controls CSA49A-600R with a White Roger 50D50-843 and I am a little confused on how to connect all the wires. Greatly appreciated any advice on how all the wires would go to the White Roger 50D50-843 unit....
I have a potterton netaheat 80E boiler and I need a limit switch part #11C19-409 by White Rodgers, can anyone help me locate this oart?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
