Ask Experts Questions for FREE Help !
Ask
    jjkstl's Avatar
    jjkstl Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Sep 24, 2008, 08:10 AM
    Ignition control changes Johnson CSA49A-600R to White roger 50D50-843
    This is my first time post.
    Hello everone
    Here is my question:
    I am replacing a Johnson Controls CSA49A-600R with a White Roger 50D50-843 and I am a little confused on how to connect all the wires.
    Greatly appreciated any advice on how all the wires would go to the White Roger 50D50-843 unit.
    Thanks.
    John
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Sep 24, 2008, 10:18 AM
    Follow this

    http://www.white-rodgers.com/wrdhom/.../0037-6576.pdf

    See wiring diagram 2/4 as posted in the Johnson change over info and use C/Green for program keys.

    All the info you need is contained in the instructions.

    If you feel you have NO idea in what you are doing call a professional for ON SITE help before you make a bad mistake. You are dealing with a safety control.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring changes: Johnson Controls G600AX-1 With Honeywell S8610U Gas Ignition Control [ 7 Answers ]

This is my very first post so... Hello everyone. and here is my question: I am replacing a Johnson Controls Pilot Gas Ignition control unit with a Honeywell 8610U and I am a little confused on how to connect all the wires. The wiring on the Johnson Controls unit is as follows: Main Valve...

Lennox Ignition Pilot Control Module [ 3 Answers ]

My problem with my Lennox furnace (model G23Q-3/4-100-2) is blowing cool air, and only occasionally heat was diagnosed as needing a Universal Pilot Module, part #53L9001 also known as 53L90. Question, if we purchase the part how difficult is the installation?

Johnson & Johnson Co what method do they use [ 2 Answers ]

The question is - What method does Johnson & Johnson uses - Indirect for direct method base on there financial statements?

Using johnson control on honeywell gas valve [ 1 Answers ]

I have a new honeywell gas valve for my furnace M# VR8345M 4302. I am trying to use a Johnson Ignition Control G770 MGC-3 to operate This valve. The problem is I want to use the intermittent function of this honeywell valve And the johnson igniter control has no provision for the mv/pv on the...

Ignition control module short where? [ 3 Answers ]

I have a 1991 Ford Ranger 4 wheel drive with the 2.3L 4 cylinder engine. It has new wires, coil packs, and crank shaft position sensor. There are no burnt wires, fuses, or fusible links. There are also no chafed, pinched, or loose wires or connections in the harness yet I keep burning the Ignition...

View more questions Search