 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Toto in wall toilet installation
I had two in wall toto toilets installed and brand new plumbing throughout the house. The in wall unit has a black drain elbow that feeds directly into the pvc drain. My plumber cemented that elbow to the pvc drain. I think a rubber connector should have been used at that junction. I'm concerned that future repairs or replacement will be made much harder by what he did.
|
||||
Check out some similar questions!
It is impossible to get back to the connection to the toilet, the Toto Aquia skirt wraps around and hides the connections. Is there an extension to connect the junction valve for the washlet to the water supply and goes to the toilet. If so, does the junction valve just "hang" only connected to...
When one commode is flushed, it drains the available water for flushing in the other commode, which, in turn, reduces the water available to flush in that commode. Any solution?
Bought 2 new Toto Drakes and installed them. After they are flushed and almost finished refilling they make a gasping noise which is coming from the greenish box in the tank. Is this normal? I was under the impression these were pretty quiet toilets. Should I contact Toto about this?
Toto toilet tank isnide unit on the left shoots out water at the top when flushing.
Question and problem: Basement was plumbed for a future bath. Cut off cap from3 inch pvc, threw a bucket of waterinto pipe and it went away. Put on flange and installed new , top of line TOTO toilet. Filled tank with water. Flushed and water filled bowel. Did not go down for over an hour....
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
