Ask Experts Questions for FREE Help !
Ask
    s.wuerth's Avatar
    s.wuerth Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 11, 2010, 03:29 PM
    Installing washlet on existing toto aquia toilet
    It is impossible to get back to the connection to the toilet, the Toto Aquia skirt wraps around and hides the connections.
    Is there an extension to connect the junction valve for the washlet to the water supply and goes to the toilet. If so, does the junction valve just "hang" only connected to two water supply hoses?
    Stetzman's Avatar
    Stetzman Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Feb 2, 2013, 08:42 AM
    How does the Toto Aqua Toilet perform with a septic system? Are there any issues that I should be aware of?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Should my Toto Drake Toilet be making a gasping sound? [ 1 Answers ]

Bought 2 new Toto Drakes and installed them. After they are flushed and almost finished refilling they make a gasping noise which is coming from the greenish box in the tank. Is this normal? I was under the impression these were pretty quiet toilets. Should I contact Toto about this?

Installing & connecting new toilet drain pipe to existing septic [ 3 Answers ]

How do I install a new toilet and shower drain pipe system and attach to existing septic system. I've already opened a 24" wide and 42" deep path through the concrete foundation, under house wall and down to the existing septic drain pipes.

Toto toilet tank inside unit water coming out at the top [ 7 Answers ]

Toto toilet tank isnide unit on the left shoots out water at the top when flushing.

Toto toilet not going down [ 3 Answers ]

Question and problem: Basement was plumbed for a future bath. Cut off cap from3 inch pvc, threw a bucket of waterinto pipe and it went away. Put on flange and installed new , top of line TOTO toilet. Filled tank with water. Flushed and water filled bowel. Did not go down for over an hour....

Installing a toilet, sink and tub in attic using existing stack [ 1 Answers ]

Hello, I am installing a toilet, sink and tub into my attic space that I am finishing. My question is: how can I tie into the existing 4" stack without affecting the fixtures below. Presently the stack acts as a vent for the lower story fixtures. Will I need to re-vent the lower fixtures in...

View more questions Search