 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Honeywell rth2300b thermostat not working
I just installed the RTH2300B thermostat on my gas f/a furnace. The furnace will cycle on / off but the fan runs consistently. Yes 'auto' is selected for the fan!
I am guessing that one of the wires is installed in the wrong slot, any ideas? Honeywell was no help, do the wire colors correspond to the letters on the thermostat terminals? If not then what is the correct order? |
||||
Check out some similar questions!
Replaced old thermostat with rth2300b. Everything works OK except no heat. Fan comes on but the air isn't warm. 4 wires come out of the wall to the control unit: Red wire missing a label White wire labeled O Green wire labeled G Yellow wire labeled Y Terminals on unit are labeled: B, O, G,...
I am trying to install a Honeywell RTH2300B thermostat. I can't get the wiring. I have a red, blue orange, green, yellow, brown and white wire and B, O, G, Y, W, Not Used, R, and RC terminals. How I have Wired: B-blue O-orange G-green Y-yellow W-white Not Used- R-red
Our old Venstar thermostat died this morning so we bought a Honeywell RTH2300B to replace it. We carefully labeled all of the wires before removing from old thermostat. We had R, Y1, W1, G and C. The instruction manual states that we should abandon the C wire. We following directions for...
Old wiring had blue to W, red to R, pink or white to S to control V2045A powerhead sectional valve. Which wires go to where on new thermostat.
I have a Honeywell RTH2300B Thermostat that I just installed. My heating system is a boiler with baseboard heat. I have three floors in my house and I have a thermostat on each floor. I only have three wires for each thermostat, a R, G, and W. When I hooked up the new thermostats the heat...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
