Ask Experts Questions for FREE Help !
Ask
    laundrylady's Avatar
    laundrylady Posts: 3, Reputation: 1
    New Member
     
    #1

    Mar 29, 2007, 12:17 PM
    Seems like no power to my washer
    I have a Kenmore Elite Catalyst washer (model # 11022052100) that was working fine, then the next time I went to use it I pushed the buttons to begin washing - the lights lit up - the water flowed through the detergent cup for a few seconds - then everything turned off. I again pushed the buttons to start the machine - the lights flickered on for a second then nothing. Now it's as if there is no power to the machine ( I did check the plug- it is plugged in and the plug works). I tried opening the lid and then pushing stop/cancel 2 times to reset but that does not help. Could it be a fuse? Please advise as to what I can do. Thanks a lot.
    tickle's Avatar
    tickle Posts: 23,796, Reputation: 2674
    Expert
     
    #2

    Mar 29, 2007, 01:29 PM
    Did you actually check the fuse box in your house ?
    laundrylady's Avatar
    laundrylady Posts: 3, Reputation: 1
    New Member
     
    #3

    Mar 29, 2007, 04:05 PM
    Thanks for your response. Yes I did check the circuit breaker and all is OK. The plug is working for the dryer so I know it's not the juice to the plug.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Washer Overflows in an unusual washer drain [ 6 Answers ]

HI My wife and I moved into a home that was built in the 50's and before we moved (aug 2006) in we had the septic checked and it was completely empty. All the drains in the house drain fine except for the washer drain overflows. It is an unusual or atypical drain than what I am used to seeing....

Car won't start, no click and no power to radio, power window or locks [ 6 Answers ]

After installing a new starter on a 1999 2WD Explorer it will not start. There is no click when trying to start it, its just dead, and the radio, power locks/windows, a/c, and dash light don't work but the interior lights work and so do the headlights. We've had the starter checked to make sure...

Husky Power Washer [ 2 Answers ]

How do you remove a broken wand that is inside the spray nozzle?

Power washer [ 1 Answers ]

My power washer is gas powered and it runs until i pull the trigger it cuts right off there seems to be a problem with pressure not building up what's wrong with it if i start it up it will keep running till i start washing , sometimes no water comes out or in spurts

Husky Power Washer [ 1 Answers ]

Newly purchased replacement sprayer wand will not insert far enough to allow a twist and lock into place.


View more questions Search