 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Replacing a baseboard tile that fell off
A small tile on the corner of my kitchen fell off. How can I reattach it without calling a tile person. There is a lot of old cement stuck to the back of it.
Also, would Superglue work? |
||||
|
|
|
||||
|
Use an adhesive caulking.
|
||||
|
|
|
||||
|
Sorry for late reply but I use Acrylpro, couple of small dabs.
|
||||
|
|
| Question Tools | Search this Question |
Check out some similar questions!
Hi, I laid down 13"by13" tile for my bathroom floor, and it looks pretty good. I have enough tile left over to make a tile baseboard. The width could be anywhere from 3 inches to 6.5 inches. What would be best? Would the finish edge at the top look strange? How could I make it look best? ...
We have not been able to replace thermostats with 3 wire type. Lowe's employee told us to buy 4 wire and cut off 1 and install. This is the second time we replaced thermostats in one year. The heat just keeps running. Is it possible we need to replace baseboards or it sounds like we have the...
My porcelain tile comes with a bullnose that I want to use as the baseboard. I found a response to another question, stating that the floor should be installed first, but I want a grout line between the floor tile and the baseboard, it would be very hard to make it uniform if the floor is...
Hi I hope someone can help me because I am lost. I have 2 brand new baseboard heaters(1500w) and they are controlled by a UPM digital thermostat(also new) These were install by an electrician last year and until today no problems. Today I am preparing to lay a new floor and I stood one of...
Hello - I am putting in a ceramic tile floor in a bathroom and plan on cutting the tiles and using them for a baseboard. Is there a correct size that this baseboard should be? And should I put anything on the top edge of the tile to finish it off? Any information would be appreciated. Thanks!
View more questions Search
|
