Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Harbor breeze 72 in. fan
[ 1 Answers ]
I just installed the fan and when I was going to program the remote it said to pres the SET button for 1to5 sec and the fan needs approximately 5 min to set the speeds and be ready to use. However the fan only moves a few times left and right and it stops. When I try to use it it does the same...
Harbor Breeze #0317998
[ 4 Answers ]
I need the instructions as I misplaced mine for installation.
Harbor breeze support?
[ 4 Answers ]
I replaced a remote control fan with a manual op one. I wanted to install a simple wall swith to power unit and I would change direction/speeds by hand. I bought the single pole switch and when I took the remote plate off the wall there were two blacks connected with a wire nut, two whites...
Harbor Breeze Fan
[ 3 Answers ]
We have a Harbor Breeze fan in our bedroom, its almost directly over our bed. The fan itself works fine (remote etc) but at low and mediom speed it has an anoying "click" which drives us nuts. I took the blades off checked for any screws touching the armiture, ran it with out the blades and I can...
Harbor breeze fans
[ 1 Answers ]
Had the fan installed correctly, used it for a year so far, one day stopped spinning and lighting. Had a meter on the electrical outlets all work fine. Is there a fuse in the fan itself, or do I have to get back in there and check wiring? View more questions Search
|