Ask Experts Questions for FREE Help !
Ask
    mistydawn57's Avatar
    mistydawn57 Posts: 8, Reputation: 1
    New Member
    		  
    #1

    Sep 18, 2013, 03:12 PM
    Help needed with hot tub pump union question
    I am repairing my hot tub. The pump union cracked. It is 2.5" schedule 40 pvc. the union and a right angel elbow need to be joined by a coupler. my ? is what size couple do i need with 2.5" lines?
    mistydawn57's Avatar
    mistydawn57 Posts: 8, Reputation: 1
    New Member
    		  
    #2

    Sep 18, 2013, 05:01 PM
    Wow feel blonde... id use a piece of pipe not a coupling lol omgoodness
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #3

    Sep 19, 2013, 11:09 AM
    Hi Misty

    I would contact the manufacturer of your specific hot tub... they should be able to help you here.

    A common pipe coupling, union, etc. may not swap out for hot tub parts... ;)

    Good luck!

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hot tub pump not cycling, will that disable my heater to not function? [ 1 Answers ]

I have a cal spa eliminator series spa and my pump is not functioning.I have one ordered but I noticed my heater light does not come on anymore so just curious if a non working spa pump will not allow the heater to function I guess since water would be not cycling through pipes?Of so, how does it...

How do you get rid of Hot tub folliculitis in your hot tub? [ 3 Answers ]

How do you clean your hot tub when you have had this bacteria (folliculitis)in it. It's the middle of winter(-25 C) and I will not be able to fully empty tub. Is there some chemical you can put in the water? I have maintained proper chemical levels. I use bromine instead of chlorine.

GFCI neutral bar/pigtail question for hot tub [ 1 Answers ]

I have a 240 volt hot tub (4 wire) and it's wired in a spa pack to a GE 50 AMP GFCI breaker. An electrician did the wiring and connected both the hot tub neutral and the gfci pigtail to the neutral bar instead of to the neutral of the gfci breaker. According to everything I've read here the GFCI...

Speedball1 >> Dielectric union question [ 4 Answers ]

Have connected a galvanized 3/4" water pipe to a copper fitting inside a wall and wondered how important is it that these are separated by a brass type fitting or union? OK to use a union inside an outside wall? Thanks, Flickit

Hot water heater union fittings [ 1 Answers ]

I am taking out a 50 gallon hot water heater and replacing it with a tankless. The first problem is taking out the old tank. It does not have a typical union at both the hot and cold water pipes. It looks like a fitting which can be rotated and both ends should rotate out. I have never used this...

View more questions Search