 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Abs inside toilet flange sits too high
I have been reading like crazy and can't find a solution. Just bought a house and the toilet downstairs leaks every time it is flushed. Took the toilet off and the flange is 1/2" high. I was going to cut it off and install an inside flange but it is already an inside flange glued in place. It's 4" abs pipe in a concrete basement floor.
|
||||
Check out some similar questions!
DO they make smaller flanges? I pulled my toilet to put tile down and now can not get a flange on it. I am very frustrated and about ready to call a plumber.
Hi i'm looking for recommendations on how best to remove the integral test cap from my abs toilet flanges. I was intending to drill them out using a hole saw bit of the appropriate size. Flanges are installed & glued to drain line. Plumbing rough-in is approved and has been air pressure tested....
I am trying to install a new toilet flange in a new construction home with a ceramic floor/concrete base. 1) how low do I have to cut off the existing soil stack. 2). How do I secure the new flange to the ceramic or concrete. (With a plywood subfloor, I would just use ABS glue on the joint and...
I need a closet flange with 1 to 2 inch offset to fit inside a 3 inch abs pipe. Is such a product available? As reference, the 3"x3"PVC Two Finger Toilet Flange, Jones Stephens Corp part# C47-33P fits, but I need the offset. Thank you.
Please Help! I am installing a new KOHLER toilet and I have purchased a new PVC toilet Flange which sits inside of my waste pipe, I primed and sealed it to the existing waste pipe and it sits too high off the floor, the toilet will not go to the floor with this type of flange, and if I saw it off...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
