Ask Experts Questions for FREE Help !
Ask
    acmlmb's Avatar
    acmlmb Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 19, 2013, 08:02 AM
    Replacing cracked toilet pipe
    My toilet leaked into the basement and the arm of the stack sits on 2 floor joists. The basement is finished but I took down a few tiles in that area. The plumber came and put two new wax rings on (since they had squirted out from under the flange? And filled a gap in the front of the ring as well. It was good for about a week and is now leaking again. I had found a piece of cast iron collar on the top of the ceiling tile when I took it off and showed it to the plumber. He thought it would still be okay because it was a piece high enough up on the stack. If I do need to replace that part of the stack (cast iron) will the floor need to be torn up in that area? Should I go with PVC for the new waste line? I live in the Chicago area - anyone know how much this will cost me?

    Thanks ~
    ACM
    Mike45plus's Avatar
    Mike45plus Posts: 230, Reputation: 27
    Full Member
     
    #2

    Aug 19, 2013, 09:31 AM
    Stacked bowl waxes will never guarantee a reliable water - tight, odor - proof, or germ free seal, and any plumber who stacks wax is not paying attention to his main responsibility , and that is to provide sanitation.
    Stacked wax gaskets are prone to failure due to shrinkage, probing by a snake or auger, and water erosion - a properly installed wax ring will never get wet, unless there is a blockage in the pipe it is connected to.
    Stacked gaskets will also fail under the slight pressure created when the toilet bowl fills up and overflows due to a pipe blockage...
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #3

    Aug 19, 2013, 01:36 PM
    No idea on cost and no idea what is involved without being able to see the job. I suggest that you call a few local plumbers and discuss options/estimates of cost with them. In this way, you can make a well-informed decision... ;)

    Mark

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Broken pipe while replacing toilet flange [ 3 Answers ]

We were removing a broken flange after a friend advised us to try and separate it to weaken the seal. We used a flathead screwdriver and a hammer to wedge between the two. The outside pipe broke too. We tried to go to the next lip and planned to replace it. Now the elbow broke!! We are on a...

Toilet Lead Pipe Drain? Any way out of replacing? [ 1 Answers ]

Help, please. I am responsible for the pipes in my tiny co-op apt in the big apple... and want to the best for my neighbor below me - my toilet lead drain pipe (building is over a 100 years old) drain had a small leak - did my due diligence and have had 3 plumbers look at it. There is a small...

Replacing toilet flange when pipe 2 1/4" below floor [ 4 Answers ]

I've got a 4" cast iron waste line with a slab floor. The pipe is 2 1/4" below the floor surface. The replacement flanges I have found are only 3" long. Is this 3/4" enough for a good seal? Does anyone know if there are longer replacement flanges out there? Thanks

Replacing Lead Toilet Drain Pipe [ 1 Answers ]

The soil pipe for the toilet in my bathroom is also connected to the tub and sink drains directly below the toilet. The sink drain leaks where it connects with the 4" lead drain pipe. The lead drain pipe then connects to a cast iron elbow. I want to replace the lead portion with PVC and also...

Replacing/reparing a cracked toilet flange [ 1 Answers ]

While setting in a new toilet the old toilet flange cracked creating a problem with securing the new toilet bolts. How do I remedy this problem? How do I repair the old flange or replace the cracked flange with a new one?


View more questions Search