Ask Experts Questions for FREE Help !
Ask
    Mike47's Avatar
    Mike47 Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 26, 2007, 02:26 PM
    New Installation Goodman GMS 91155 DXA eff 93%
    HI
    My Goodman furnace will not (repeat cycle) . Furnace will operate, but after it reaches
    The desired HEATING TEMP, it shuts down and will not recyle, when the temp drops.
    I then get the 3 blink flashing light---indicating (pressure switch is stuck open).
    Then I turn the furnace off for about 1 hour then adjust the thermostat to desired temp
    And the furnace will ignite and bring temp up to desired setting.
    Appreciate your help, and I thank you. Mike
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
     
    #2

    Mar 27, 2007, 01:22 AM
    Flue pipes are possibly the wrong size, best guess.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane vs Goodman [ 14 Answers ]

I'm going to buy two replacement 13 SEER R-22 heatpumps - outside and air handlers. The Trane is $1800 more ($900 x two) and gives me a 10 yr warranty on the compressor vs. 5 yr on the Goodman - all else is the same. Is the Trane with its extra 5 yrs worth it?

Goodman Furnace [ 2 Answers ]

How old is my Goodman furnace and how efficient is it? Model GUEQ80-4REVS Serial #910482720

Goodman 4 ton HP [ 7 Answers ]

I have a Goodman 4 ton HP CPJ60-1. Outside unit was coming on but the inside blower motor did not come on. Now the outside unit does not come on at all in either mode. Where should I look?

Goodman [ 2 Answers ]

I'm shopping for a new forced air furnace. The lowest price I have is for a high efficiency furnace made by Goodman. Never heard of this manufacturer. What is the quality rating for Goodman high efficiency furnaces? Thanks

Goodman Furnace [ 3 Answers ]

I have a six year old Goodman Furnace that will not kick on or even begin the start up cycle. Last year I replaced the ignitor and checked it out today and looks fine. Any obvious place I should start to determine the issue? Thanks Jim


View more questions Search