Ask Experts Questions for FREE Help !
Ask
    dispatcher39's Avatar
    dispatcher39 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 22, 2013, 05:53 AM
    Husqvarna Problems
    I have a husqvarna model YTH 2348 lawn tractor with a Briggs 23 hp INTEK engine.
    It ran fine at last use and one week later when started it was popping back thur the carb on one cyl. It has 160 # compression on both cyl,s.(It does not pop when both spark plugs are removed) It has good spark. It will run but only on one cyl.
    Any idea?
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Aug 5, 2013, 04:49 PM
    Hi,
    Check the valves.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Problems with husqvarna 2554 with Kohler engine [ 9 Answers ]

I have a Husqvarna LGT 2554 with a Kohler engine. Engine starts and runs fine for about 30- 45 minutes then just dies. Let sit for a while and then starts and runs fine for about 30 minutes. Repeat. Repeat etc. mower is less than two years old and has low hours. Only use it to mow my yard. ...

Husqvarna yth2448 carburetor problems? [ 1 Answers ]

I've got a husky yth2448 w/briggs engine. Solved my air filter problem, rebuilt carb. Now it runs for 20-30 minutes and wants to stall. I have to pull out choke to keep it running long enough to get it back to garage. I replaced plugs, fuel filter and lines, oil, air filter. I am ready to drive...

Lawn tractor problems/Husqvarna model#LOGTH2448T [ 2 Answers ]

Have two issues: 1. Battery won't stay/hold a charge. What recharges the battery? 2. While running with PTO engaged the blades quit cutting. Engine runs fine. Thanks-RTF

Husqvarna Riding mower - carb problems [ 4 Answers ]

Hello, I have ~2005 Husqvarna riding mower with a Briggs & Stratton Vanguard engine (model #385777), that has started running poorly. The first time this happened I was pretty sure that I had gotten some bad gas... it started missing a little, then progressed to backfiring, and finally noticed...

Problems with husqvarna yth2448 [ 6 Answers ]

My mower stops cutting on its own, and will not start cutting again until started up again only to stop cutting again a few minutes later.:confused: :mad: :

View more questions Search