Ask Experts Questions for FREE Help !
Ask
    jhawk1340's Avatar
    jhawk1340 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 23, 2013, 09:03 AM
    Intermitten singal at two wires going to pto
    The wires going to p.t.o. are getting a intermittent single can't get it to engagel
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #2

    Jul 19, 2013, 09:24 PM
    Hi,it
    Is a bad switch or a short. Kind of 50:50 there.
    Peace,
    Clarke

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ecm blower intermitten [ 1 Answers ]

Dayh 060 coleman rooftop gas pack blower ramps up and down and sometimes goes out completely during cooling,compressor stays on. Even with a call for fan only.

Well pump runs intermitten [ 7 Answers ]

I have a submersible pump 115 ft down. It has a Square D pump pressure control box. It is a 1/2 hp 3 wire pump with a control box near the well. The pressure tank has a bladder. My problem is that the pump stops at times. The pressure gage gets hung. The pressure control box contacts engage...

Pto clutch wires cut, fuse blown, engine still doesn't turn over [ 2 Answers ]

I have a troy-bilt 14 hp ltx lawn tractor. While turning off the pto switch, noise followed, then mower shut off... discovered the black/white wire to pto clutch was severed and the plug pulled out... the 30 amp fuse was also blown at the ignition switch.. I spliced the wires and plugged back in...

Getting a Check singal cable message [ 3 Answers ]

I have a brand new monitor that I hooked up to my docking station and although everything seems to be connected properly, I am getting the "check signal cable" message. Since the only thing I had to connect was the power cord and the monitor cable, I am a little confused as to why it is not...


View more questions Search