Ask Experts Questions for FREE Help !
Ask
    Sabuet's Avatar
    Sabuet Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 10, 2013, 02:59 PM
    Kirkland Signature Clothes Washer by Whirlpool appears to have lost all power to it.
    The Whirlpool washer suddenly stopped and appears to have lost all power to it. The power supply has been verified. This occurred when it was about to start draining from full capacity. Bought in 2004.
    Model: SAWS800MQO
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Jun 10, 2013, 11:08 PM
    Here are the manuals: https://dl.dropboxusercontent.com/u/...%20Washers.zip
    https://dl.dropboxusercontent.com/u/...c%20washer.pdf
    https://dl.dropboxusercontent.com/u/...e%20Manual.pdf
    You will need a meter to diagnose what is wrong. One thing that will stop it dead like that is a stopped up water valve. Remove the hoses from the back of the machine and pull out the screens from the inlets on back of machine and clean them with an old toothbrush. Check both ends of the hoses for screens, too. Once unstopped it will run normally.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kirkland signature dryer by whirlpool [ 1 Answers ]

My Kirkland dryer is heating up and tumbling but is not blowing the air out the vents and drying the clothes. I've checked the vents for clogging but still not drying. Do you have any suggestions?

Kirkland signature whirlpool washer [ 0 Answers ]

Whet does the gasket go?

Kirkland signature dryer by whirlpool does not come on. [ 0 Answers ]

Kirkland signature dryer by whirlpool makes humming sound for a few seconds but does not come on. Took off back panel, belt on drum is not broken. Could it be a fuse of some sort?

Whirlpool Kirkland Signature Dryer [ 1 Answers ]

I Have a Whirlpool kirkland signature dryer. It won't start. I set the dial on timer, open the door and push the door sensor and can hear the timer ticking. Reading the post it seems it could be the thermal fuse of the fuse to the door switch. Where are the panels located to open up the unit...

View more questions Search