Ask Experts Questions for FREE Help !
Ask
    paloyd's Avatar
    paloyd Posts: 1, Reputation: 1
    New Member
     
    #1

    May 20, 2013, 02:10 PM
    How to test faulty seat switch on sears ride on
    I have a Craftsman ride on, first cut of the season it fired right up and ran great. Now it turns over but won't fire, lots of fuel and spark. What do I check next and how?

    Paul
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #2

    May 20, 2013, 04:48 PM
    The seat switch functions by grounding the ignition when you get (or fall) off the switch. To test, you simply unplug the wire to it. With the wire disconnected it can't ground the ignition.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Sears ride on mower steering tie rod troubles [ 2 Answers ]

I have an older circa 1987 16 hp 6 speed 44" ride on mower. One of the tie rod ends keeps dropping down from the steering plate where the 2 tie rods are under the steering plate or bellcrank as the part is called in the parts manual. Not sure on the best remedy I was able to push it back in but it...

Faulty pressure switch? [ 0 Answers ]

I have a 7-8 year old york 80 upflow model that will not turn on when the heat is turned on. The blower works when the fan turned on the thermostat and the a/c works. Last night, the heat did work before I went to bed. The humidifier was turned on and when I woke up in the middle of the night...

New switch, possibly faulty? [ 15 Answers ]

I have a double light switch (both Single Pole) which went bad... I picked up a new switch which looks to be the same (2 hot terminals, 2 neutral)... I hooked everything up the same way as the old switch (which also had 2 hot, 2 neutral lined up the same).. Now the switch turns on both lights at...

Faulty pressure switch [ 2 Answers ]

I have a Concord 80 Plus Gas Furnace. I had a friend look at it when it was blowing out cold air when turned on, and he said the burners were not kicking on for some reason. When taking a few things apart, he determined that it was due to a faulty pressure switch. When the two wires that attach to...

Faulty limit switch? [ 6 Answers ]

Toward the end of a heating cycle, the burners would shut down and the fail code would read "open limit switch". The repairman said the limit switch was faulty and installed a new one a couple of days ago. It seemed to work fine until this morning, and now it's doing the same thing as mentioned...


View more questions Search