Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How difficult is it to replace a 2" vent in concrete with a 3" for a new waste stack?
[ 2 Answers ]
I have one side of my house that is unfinished. It has two roughed in bathrooms and the plumbing is in concrete. The stack is 2" because they didn't plan on a bath upstairs. I want to add a bathroom upstairs so can I cut the concrete and put in a 3" Wye to create my waste and vent stack,...
Can water seep under silicon-based caulk through a "sandy" concrete floor?
[ 2 Answers ]
I've fitted a new weather-bar at the base of an external door, bedded on plenty of silicon-based caulk for good measure. Water still seeps into the house at an alarming rate when the wind is up. My suspicion is that the water ingress is through the "sandy" concrete base on which the weather-bar...
Can you install composite wood deck over concrete slap by gluing?
[ 4 Answers ]
We have a concrete slab, covered patio and would like to install composite decking. Can we just glue them to the concrete?
Tying 2" drain pipe to perpendicular 3" drain line under slap
[ 3 Answers ]
I want to avoid a 90 degree bend under slab. However, I have to reduce from the 2" pipe that drains the WM to the 3" main drain line, and the reducing tee I find has a very small sweep. Do I need to use a reducing combination wye and is there such thing?
Pouring Concrete Slap over Concrete piers
[ 1 Answers ]
I drew a fairly detailed drawing of the slab that I wanted, with the piers (flagpole support piers, with pipes down to put poles into) shown so they could do it all in one pour. Well, I guess our general contractor cannot read the drawings because all I got were the piers with the metal in them. ... View more questions Search
|