Ask Experts Questions for FREE Help !
Ask
    agarwal100's Avatar
    agarwal100 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 12, 2013, 06:01 PM
    Kenmore Elite dishwasher start button blinks does not start
    The washer does not start. The start button light keeps blinking green.
    agarwal100's Avatar
    agarwal100 Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Apr 12, 2013, 06:03 PM
    I pressed the Normal Wash, Hi Temp, cycled the Heated Dry button 3 to 5 times. The washer started. Apparently the sequence resets the washer.
    rcaldwell's Avatar
    rcaldwell Posts: 39, Reputation: 2
    Junior Member
    		  
    #3

    Apr 12, 2013, 06:13 PM
    When the clean light is blinking the dishwasher control board is sensing a fault in the water heater. Take off the dishwasher toe-kick panel to get the diagnostic sheet and run the diagnostic cycle. This will clear the error. If it returns then you have a heater fault. Check the heater for any bubbling or arcs. Repair or replace it if necessary. Also, check the controller in the front panel for any scorching or heat stains. You may have a intermittent contact there. Hope this helps,
    Richard,
    >advertising removed<
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #4

    Apr 13, 2013, 01:49 PM
    See if this helps: https://dl.dropboxusercontent.com/u/...Dishwasher.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore dishwasher doesn't want to start when I push the start button [ 0 Answers ]

Have to keep opening and pushing the buttons trying to make it start

Kenmore elite dishwasher will not start [ 0 Answers ]

My Kenmore Elite dishwasher will not start - Mod 665.16462300 All the buttons on the left will light up including: SmartWash/AntiBact/PotsPans/NormalWash/ChinaGentle/QuickRinse/Hightemp/SantiRinse/AirDry But the buttons on the right will not light up: Delay / Cancel / Start I replaced...

Sears Kenmore Dishwasher start button won't start unit [ 0 Answers ]

I have a Kenmore Ultra Wash dishwasher that will not start when pushing the start pad location. It will pump when put on the Cancel/Drain button, but will not start after that. It does have power, or the pump would not run during the Cancel/Drain cycle. The washer was purchased in Jan 20, 2006...

Kenmore Elite Dishwasher Not Start [ 1 Answers ]

Dishwasher does not start. Checked electrical panel, diswasher connection, door switch all OK.

View more questions Search