Ask Experts Questions for FREE Help !
Ask
    LOISCURLEE's Avatar
    LOISCURLEE Posts: 1, Reputation: 1
    New Member
     
    #1

    Apr 9, 2013, 07:44 PM
    What makes the breaker keep tripping after installing a new hot water heater?
    Why does the circuit breaker keep shutting of after I install a water heater?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    Apr 9, 2013, 07:58 PM
    What is the wattage rating of the new vs the old? If it trips immediately I would suspect a wiring issue, hot to ground. If it trips after a while, I would suspect an overloaded breaker,possibly due to increased wattage. If that is the case you may also need a new wire to the heater.
    hfcarson's Avatar
    hfcarson Posts: 1,003, Reputation: 49
    Ultra Member
     
    #3

    Apr 10, 2013, 04:04 AM
    As "ma0641" asks, the more you can tell us, the better our answers...
    What size is the water heater? A common heater is 240 Volt, 4500 watts...
    This information is clearly indicated on the ID plate of the heater. What size circuit
    Breaker is the heater connected to?
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
     
    #4

    Apr 10, 2013, 04:21 AM
    Why does the circuit breaker keep shutting of after I install a water heater?
    Completely impossible to say. We know nothing about this installation.

    Read the last two replies. Follow the advice.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Electrical Water Heater keeps tripping the breaker. [ 4 Answers ]

Whirlpool Electrical Water Heater. Model no. MHE2F30HS035V The insulation between the tank and the outer metal lining is wet. (Below the lower access panel). There is no visible exterior leak or water on the floor. The water heater is on a dual 20 breaker. The lower access panel has an...

Electric water heater tripping circuit breaker [ 3 Answers ]

Hello, I have a 9 year old electric 50 gal. heater and recently it has been throwing the breaker and now it just won't work at all can this be a burnt out element or possibly an issue with sediment build up or might it be a bit of both? What is the suggested course of repair or would it be better...

No or very slow hot water from gas water heater, heater makes lot of sounds [ 1 Answers ]

There is problem with our hot water system, not getting hot water while as cold water is OK. Starting hot water there is lot of explosion sort of sounds from water cylinder and hot water will start dribbling and stops after some time.

HOT WATER HEATER tripping the breaker [ 0 Answers ]

Hot water heater tripped the breaker. Reset it and it did not trip again, but does not heat the water. Is it my elements? Please advise. Thanks, Robert Maday

Why does my hot water heater keep tripping the circuit breaker? [ 4 Answers ]

I bought my home approximately 1.5 years ago and had installed a new GE hot water heater at that time. For several months now, it keeps tripping the circuit breaker. I noticed lately that when I go to reset the circuit breaker, that particular breaker is hot to the touch, not warm but hot. Could...


View more questions Search