 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Free Electrical Questions
Want to add circuit that controls front and rear cameras along with tft monitor... am using on/off/on switch where on #1 sends power to rear camera + monitor and on #2 sends power to front camera + monitor... however wiring power to monitor from both sources creates backfeed that turns BOTH cameras on... how/should I use diodes or relay to prevent backfeed??
|
||||
Check out some similar questions!
What size and type wire do I need to go from the meter to the service point for a 2oo amp residential service
Can you have a 480 volt primary transformer feed in the same pipe with 120 volt Branch circuits. Can you share a under ground vault with 480 volts and 120 volts arriving and leaving in separate conduits.
I would like to know the cost of installing a single lite switch a single receptacle in afinished wall made of lathe and plaster. Going to my basement. Wire usage would be about 40 ft. my box is in the basement the sw is going to 3 small can lites over a bar a box was built for them. The receptacle...
there are 3 questions here. question 1. I am replacing a older newtone bathroom ventilation fan with a panasonic fan same 110 cfm. My question is the old newtone fan just pluged in for installation and the new one is for hard wiring. Can a plug be put on the new panasonic fan and just plug it...
Im trying to hook up a my Q light switch from chamberlain in my house. I took the old light switch off and found 1 red wire 1 black wire 3 white wire that are hooked togther with a cap guessing that's neutral. 2 greenish black wire and one bare copper wire. The swich that I'm trying to hook up...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
