Ask Experts Questions for FREE Help !
Ask
    racerdad52's Avatar
    racerdad52 Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 28, 2013, 06:32 PM
    Installing a 30 amp load center in an enclosed trailer
    Hooking up a 30 amp load center box in an enclosed trailer. Will have a marinco 30 amp plug on the outside . Looking for a wiring diagram that will help me out. Thanks.
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
     
    #2

    Mar 28, 2013, 07:35 PM
    What are you looking for exactly? There are no stock wiring diagrams for things like this like there would be a for car or something.
    This would get wired like any other sub-panel, only the feed will come from the travel trailer plug.

    Will this be a 120V only setup? I assume so since it is 30A. That affects how the panel is wired.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can a 100 amp load center be used as a sub panel with a 60amp main breaker? [ 7 Answers ]

Hello, I`m triying to add a sub panel to my existing main panel. There is no more room in the main panel for circuit breakers and I wanter a sub panel with at least 10 more spaces.

What does 'invertible' load center mean? [ 2 Answers ]

In Siemen's literature, they state "13. All indoor Ultimate Load Centers are invertible for bottom feed applications." Does this mean that the panel can be flipped upside down so that the Main breaker is on the bottom (presumably allowed since the breaker On/Off is horizontal rather than...

Load Center Capacity [ 11 Answers ]

I have a new Square D load center installed rated at 100 amps. What does the 100 amp rating mean? If I replace the 100 amp main breaker with 200 amp breaker does that mean that The load center could melt if 200 amps flowed through it or that the incoming service wires could melt or what. Just...

600 Amp Service And Load Center With 6 Breakers [ 4 Answers ]

I Have A Overhead Service With Single Phase 220v 600amp Going To 23 Boat Docks And A Small Club House And A Garage . I Need A All New Service Change And A Rewire To The Boat Docks . I Calculated The Dock Service Demand Load According To Nec 555-12 It Comes Out To Be 486 Amps I Have 5- 125 Amp 220v...


View more questions Search