 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman furnace gas cuts off
I have a gmp-050-3 goodman gas furnace. Gas would come on for a few seconds and cut back off so I replaced the flame sensor rod. Now it comes on for about 2 min. and cuts off. I reset all roll out sensors in this area. Any suggestions.
|
||||
Check out some similar questions!
The igniter will ignite the gas, and the gas will run for a second or a few seconds and will then cut off. It will continue to cycle like this until it finally will stay on but at times will take forever.
I have a carrier gas furnace. It starts fine. That is, the inducer motor starts, the igniter glows, the gas comes on and lights, igniter goes off, the air handler starts. Runs for anywhere from 15 to 30 minutes. Even cycles a few times if house reaches thermostat setting. But eventually, always...
The status light blinks continuously which the panel states is either incorrect twinning or incorrect primary polarity. It suggests that I check "reverse transformer," "secondary leads," and "reverse primary wires." My diagram does not label these parts. Is there a part that I might replace or...
Hello, First time posting. Maintenance tech at local college. I'm working at home today though. I am relocating a gas line in the living room and need to turn the gas off at the meter. We have a Goodman gas furnance(duel fuel system)with electronic ignitnor. When I turn the gas to the house...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
